Laser Caution Label; Cards With Optical Fiber Connectors - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

Ansi
Hide thumbs Also See for 7360 Intelligent Services Access Manager FX Series:
Table of Contents

Advertisement

ANSI Hardware Installation Manual
23.6.2.2
Observe the following.
Figure
Figure 250
Procedure 96
Each 7360 ISAM WM shelf can contain one power card, or up to a maximum of two power cards.
Proceed as follows to install a 7360 ISAM WM power card:
1
2
Issue: 09

Cards with optical fiber connectors

Risk of eye damage or skin burns by laser emission.
Danger —
When installing optical cards or handling optical fibers, never
look inside connectors of cards or fibers when these are not
connected.
Put end caps on open connectors to protect against
unexpected emission.
Risk of damage by ESD when card is not
Caution —
connected.
This card contains devices that are susceptible to damage
caused by ESD in unconnected circuit conditions.
Carefully follow ESD safety precautions.
250
shows a laser caution label.

Laser caution label

To install power cards
Remove the power card from its ESD protective bag. Make sure to wear the antistatic wrist
strap.
Insert the power card in the Power A slot of the of the 7360 ISAM WM, and if required, also
insert a second power card in the Power B slot of the 7360 ISAM WM; see Figure 251.
3HH-12893-AAAA-TCZZA
Installing cards in the 7360 ISAM WM shelf
DRAFT
18455
425

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7360 isam fx-16

Table of Contents