Optical Modules - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

ANSI Hardware Installation Manual
24.2.2
WM line cards are populated with a customer-defined combination of pluggable
optical modules that provide the bandwidth required by the specific 7360 ISAM FX
system deployment; see the local plans for more information.
The number of optical modules depends on the card type. Each of the connectors
has a Tx port and an Rx port. Depending on the type of optical module, one or two
optical fibers are required to connect to the optical module.
24.2.3
Standard single-mode fiber cables with LC connectors are connected to the SFP
optical modules for transmit (Tx) and receive (Rx) purposes.
The GPON and EPON SFPs require an SC/UPC connector.
24.2.4
Fiber optic cables must be routed upward towards the top of the 7360 ISAM WM
shelf using the cable guides.
24.2.5
Fiber management guides are recommended for installment on the 7360 ISAM WM
shelves to provide proper fiber optic cable handling. The kit contains:
•
•
Issue: 09

Optical modules

Do not use unauthorized SFPs or XFPs. This can
Warning —
adversely affect the system requiring operator intervention.
For an overview of the supported SFP modules, see
Note 1 —
the 7360 ISAM FX Product Information Guide.
Nokia recommends protecting any SFP cage that is
Note 2 —
not equipped with an SFP modules with a dust cover in order to
prevent dust intrusion.
The type of optical fibers must match the particular
Note 3 —
SFP to guarantee the overall optical budget in the system and
its correct operation of the system. Loss of optical power as a
result of a mismatch in materials must be avoided.
Fiber cables
Routing fiber optic cables in the rack
Fiber management kit
fiber management guides for the line cards
fiber management guide for the power and controller cards
3HH-12893-AAAA-TCZZA
Fiber optic cable management in the
DRAFT
7360 ISAM WM shelf
433