Figure 39 Power Cable Routing For 7360 Isam Fx-16 - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

7360 ISAM FX-16 shelf cabling
Figure 39
Procedure 17
Use the following procedure to connect the power cables to the 7360 ISAM FX-16 shelf.
1
2
108
Power cable routing for 7360 ISAM FX-16
01 02 03 04 05
N594
R
A/70 FOR LT
ESD
CRAFT PORT
To connect power cables
Danger — Before connecting the power cables, make sure that the
power to the cables has been disconnected and the circuit breakers for
BAT A and BAT B are switched off.
Note 1 — Power cables connect the PDF directly to the shelf.
Note 2 — All hardware shown in Figure
7360 ISAM FX-16.
Note 3 — Avoid sharp bends in cables. Use the proper bend radius
when installing cables.
Ensure the power to the wires has been disconnected.
Loosen the screws on the safety cover and remove the safety cover; see Figure 40.
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
06 07 08 NTA NTIO NTB 09 10 11 12
Energy Hazard
7360 ISAM FX-16
B/70 FOR LT
-48V 70A
ALM
BITS INTERFACE
TIME OF DAY
NT-A NT-B
RING 1 Hz-PULSE
TIP
CAUTION: BEFORE REMOVING TERMINAL COVER,
FRAME GND
DISCONNECT BOTH "A" AND "B" POWER SOURCES
CAUTION: TORQUE NUTS TO 65 IN-LBS MAX
40 is provided with the
DRAFT
13 14 15 16
CRITICAL BAT A
MAJOR BAT B
MINOR ACO
Energy Hazard
CO ALARMS
22191
Issue: 09