Table 28 10 Mhz Gps Interface Signal List; Table 29 Tod/Pps Signal List And Pinning; Tod/Pps Interface Signal - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

Connector pinning on NT card
Table 28
Signal name
10M_GPS-IN
Shield

26.4 ToD/PPS interface signal

Table
pulse input interface.
Table 29
Signal name
ToD_UART_T/F
ToD_1PPS_T/F
EG
FG
NC
26.5 Local craft interface
Table
454
10 MHz GPS interface signal list
Type
Input
Input
29 describes signal and pinning of the ToD/PPS connector on the validation
ToD/PPS signal list and pinning
Type
Output
Input
Output
Input
REF
REF
—
30 describes the signal and pinning on the local craft interface connector.
Cabling and pinning is dependent on the device
Note —
connected to the local craft interface. An example of the DB9
cable pinning is provided in the table, however based on the
specific device used, connections may require alteration.
See your Nokia representative for more information.
3HH-12893-AAAA-TCZZA
DRAFT
ANSI Hardware Installation Manual
Description
10 MHz GPS timing reference
(sine wave, 50Ω, transformer coupled)
Frame ground
Pin number Description
8 ToD UART TX, PTP master mode (differential pair,
100Ω)
7 ToD UART RX, PTP slave mode (differential pair,
100Ω)
6 1 PPS output, PTP master mode (differential pair,
100Ω)
3 1 PPS input, PTP slave mode (differential pair,
100Ω)
4,5 Electrical ground
CASE Frame ground
1,2 Not connected
Issue: 09