Overview
2.5 Installation materials and tools
You need the following tools to install the 7360 ISAM FX system equipment. Other
tools may be required to perform special procedures as specified in the instructions.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
52
All tools used on working equipment must be insulated.
Note —
adjustable wrench, 12 in. (30.5 cm)
anchor setting tool
cable cutters
camera
carpenter claw hammer, 24 to 40 oz (0.68 to 1.13 kg)
chalk line and chalk
container for asbestos flooring drilling residue, if necessary
crimping pliers
diagonal cutters, 5 in. (12.7 cm)
digital multimeter (volt-ohmmeter)
extension cord, 50 ft (15 m)
felt marking pens
hex driver set with bits
level, 3 ft (1 m)
measuring tape
needle-nose pliers
open and box-end wrenches, 3/8 to 11/16 in. (9.5 to 17.5 mm)
#2 Phillips and flathead screwdriver
pinch bar
rotary impact drill and associated drill bits
safety glasses
shears, common
shims, 0.06 in., 0.09 in., and 0.12 in. (1.5 mm, 2.3 mm, and 3.1 mm)
shop vacuum cleaner
socket set, 3/8 in. drive with ratchet handle and extensions
static protection accessories
tin snips
torque wrench
wire stripper
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
DRAFT
Issue: 09