Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual page 307

ANSI Hardware Installation Manual
3
4
Procedure 67
Use the following procedure to route and connect 7360 ISAM FX-8 fiber cables to NT and LT
cards.
1
2
3
4
5
Issue: 09
Attach the fiber management guides as shown in Figure
STOP. This procedure is complete.
To route fiber cables to NT and LT cards
To route fiber cables to NT and LT cards, proceed as follows:
a If routing fiber cables using a fiber management guide, mount the fiber management
guide. See Procedure 66.
b If routing fiber cables without using a fiber management guide, continue to step 2.
Prepare fiber optic cables for the equipped NT and LT cards.
Label both ends of each cable with the following information, for future identification:
•
card connection name
•
Tx or Rx, depending on which port is used for the connection
Route the fiber cables from the source to the top of the rack.
If using a fiber management guide for a vertical installment of the 7360 ISAM FX-8 shelf,
route the fiber cables through the ring-guides and through the fiber management guides, and
toward the NT and LT cards. Otherwise, route the fiber cables, maintaining a proper bend
radius, toward the NT and LT cards:
a Route to the left for:
•
NT card A
•
LT cards in slots 01 to 08
b Route to the right for:
•
NT card B
•
LT cards in slots 09 to 16
Note — For NELT-B cards, 90° fiber connector strain relief boots are
required.
3HH-12893-AAAA-TCZZA
Fiber optic cable management in the
DRAFT
7360 ISAM FX-8 shelf
168 using the provided screws.
307