Figure 160 Lt Cards Slots In 7360 Isam Fx-8 - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

Installing cards in the 7360 ISAM FX-8 shelf
Figure 160
1
2
3
4
5
296
LT cards slots in 7360 ISAM FX-8
PWR PWR
A/S A/S
ALM ALM ALM
PWR PWR
A/S A/S
PWR PWR
A/S A/S
ALM ALM ALM
Energy Hazard
Locate the free LT card slots for mounting the LT cards; see Figure 160.
Remove the LT card from its ESD protective bag. Wear the antistatic wrist strap.
Caution — Risk of damage by ESD when card is not connected.
This card contains devices that are susceptible to damage caused by
ESD in unconnected circuit conditions.
Carefully follow ESD safety precautions.
Ensure the insertion/extraction tabs on the card are in the unlocked position.
Slide the LT card in the appropriate LT card slot.
Caution — When sliding the LT card into slot 1, special attention is
required so that the solder side of the LT card does not come into contact
with the EMC shielding plate adjacent to the LT card slot. If not done
properly, this may cause damage at the solder side of the LT card.
Press the insertion/extraction tabs on the front panel to lock the card in place. Attach fixation
screws located at the top and the bottom of the front panel of the card; see Figure 160.
Maximum torque: 2.66 lbf-in. (0.3 N.m).
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
7360 ISAM FX-8
B-40A
A-40A
NTA GND NTB
External Alarms BITS TOD/IHZ Remote Craft
DRAFT
Alarms
FAN
Critical
Major
Minor
BAT A BAT B ACO
22385
Issue: 09