Copper Gigabit Ethernet Nic Connectors And Cables; Figure 11 Gigabit Ethernet Cable Connector Pin Assignments - Nokia IP290 - Security Appliance Installation Manual

Note
The Link LED on the NIC is bicolored. A green LED indicates a 1 Gbps link speed, and a
yellow LED indicates a 10/100 Mbps link speed. As the NIC transmits data, the activity LEDs
on the appliance illuminate.

Copper Gigabit Ethernet NIC Connectors and Cables

The copper Gigabit Ethernet NIC receptacles are for RJ-45 connectors.
Caution
Cables that connect to the Gigabit Ethernet card must be ANSI TIA/EIA-568-A/B
compliant (Cat 5 or Cat 5e) to prevent potential data loss.
To connect to a 1-Gbps hub, switch, or router, use a straight-through RJ-45 cable (Cat 5 or Cat
5e type cable, or as required by your network configuration).
In Figure
pins facing up and toward you.

Figure 11 Gigabit Ethernet Cable Connector Pin Assignments

Nokia IP290 Security Platform Installation Guide
11, the RJ-45 cable output connector is numbered from right to left, with the copper
8 1
Two-Port Copper Gigabit Ethernet NIC
1000 Mbps
Pin# Assignment
1 BI_DA+
00270
2 BI_DA-
3 BI_DB+
BI_DC+
4
BI_DC-
5
6 BI_DB-
7 BI_DD+
8 BI_DD-
10/100 Mbps
Assignment
TX+
TX-
RX+
RX-
41