Fiber optic handling and acceptance criteria
27.2 Handling considerations
Figure
Figure 260
Consider the following when handling fiber optic devices and accessories:
•
•
•
•
•
458
In a fiber distribution network, it is an industry best
Note —
practice to use APC-based connections or spliced
connections to avoid any potential network problems. Nokia
recommends that the unused ports of splitters be terminated
into an APC-based connector.
260
shows the main parts of a fiber optic cable.
Parts of a fiber optic cable
ensure the bend radius for single-mode optical fiber cable is not less than 4 in.
(102 mm), and the bend radius for multimode optical fiber cable is not less than 6
in. (152 mm)
handle cables with care; avoid twisting the cable while turning its connectors or
routing the cable during installation
connect or disconnect a connector by holding the sides of the connector and
pulling gently
do not pull on the boot of the connector
do not touch the fiber cable end-faces
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
Core
Cladding
Ferrule
Cable
DRAFT
Connector
Boot
Issue: 09