Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual page 244

Installing a 7360 ISAM FX-8 shelf
•
•
•
•
•
•
Procedure 50
Use this procedure to mount a 7360 ISAM FX-8 shelf horizontally in a 23 in. rack.
1
2
3
4
244
horizontal shelf mount kit containing:
•
shelf horizontal brackets (x2)
•
12-24 × 1/2 in. (12.7 mm) screws
•
6-32 × 3/8 in. (9.53 mm) screws
vertical shelf mount kit containing:
•
rack adapter brackets
•
pre-assembled top cross bracket, rear skirt and front skirt
•
pre-assembled shelf horizontal mount bracket and air intake baffle/drip tray
•
intumescent panel
•
top baffle
•
12-24 × 1/2 in. (12.7 mm) screws
•
M3 × 5/16 in. (8 mm) screws
•
M3 × 9/16 in. (14 mm) screws
•
M3 × 9/16 in. (14 mm) screws
•
12-24 × 1/2 in. (12.7 mm) screws
fan unit (BFAN-E))
8 AWG power lug
general facilities card, if replacing (NGFC-H)
cables:
•
50-pin micro DSUB connector
•
DB-9 connector
•
RJ-45 connector
•
6-pin wire-wrap right angle header connector
•
120-pin FCI power blade connector
To mount the 7360 ISAM FX-8 shelf horizontally in a 23 in. rack
Unpack and inspect the shelf visually for physical damage.
If anything is missing or damaged, notify the transportation carrier and Nokia immediately.
Photograph all the damaged equipment. Keep all the inspection and packing documents as
a reference.
Warning — Possibility of equipment damage.
Do not install damaged equipment, as it can adversely affect other
equipment.
Put on the antistatic wrist strap and connect it to a grounding point.
Verify the 7360 ISAM FX-8 shelf mounting locations on the rack; see Figure 128.
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
DRAFT
Issue: 09