Work Mode - Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual

168
Driving and parking
Activating or deactivating warning
Select Lane Keeping Assist
#
Keep. Asst On.
Select Warning.
#

Work mode

Activating/deactivating power take-off
Observe the following notes:
if there is severe strain on the power take-off,
R
e.g. due to a high power draw at high outside
temperatures, the transmission oil tempera‐
ture can increase to impermissible levels. In
this case, operate the power take-off at regu‐
lar intervals for about five to ten minutes
under a partial load.
only activate the power take-off when the
R
vehicle is stationary and the transmission is
in neutral position.
make sure that the engine speed is not higher
R
than 2500 rpm during operation.
manual transmission is disabled in vehicles
R
with shift lock when the power take-off is
activated.
you can engage 1st or 2nd gear and drive
R
after activating power take-off in vehicles
without shift lock. Do not change gear while
the vehicle is in motion when power take-off
is activated. Therefore, pull away in 1st or
2nd gear depending on the desired speed.
observe the notes in the manufacturer's oper‐
R
ating instructions before using the power
take-off in conjunction with the body.
To activate: stop the vehicle and shift the
#
transmission to neutral.
#
or Act. Lane
#
#
#
#
#
#
ADR (working speed control)
Function of ADR (working speed control)
When activated, ADR automatically increases the
engine speed to a preset speed or a speed you
have set.
%
depress the clutch pedal.
wait about five seconds and with the engine
running press the upper section of the switch
1.
release the clutch pedal.
On vehicles with a working speed governor
(ADR), the engine speed automatically increa‐
ses to a preset speed or a speed you have
set, the constant engine speed. The
speed governor active and
active messages are shown in the multifunc‐
tion display.
To deactivate: stop the vehicle and shift the
transmission to neutral.
depress the clutch pedal.
wait about five seconds and with the engine
running press the lower section of the switch
2.
release the clutch pedal.
After a cold start, the idle speed of the
engine is increased automatically. If the pre‐
set working speed is lower than the
increased idle speed, the working speed is
only reached once the engine has completed
the warm-up phase.
It is only possible to activate ADR with the
vehicle stationary and the parking brake
applied.
On vehicles with automatic transmission, the
selector lever must be in position j.
Working
Power take-off