Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 71

Installation position of three-person rear
bench seat
1
First row of seats
2
Second row of seats
3
Third row of seats with three-person rear
bench seat
Install the three-person rear bench seat only
#
on the third row of seats
axle.
Removing the rear bench seat
To remove the covers of the mounting
#
shells: push clip 1
arrow and detach cover
top rear at an angle.
3 above the rear
in the direction of the
2 by pushing to the
Push release handle
#
the way down and hold it there while tilting
the bench seat backwards slightly at the
same time using the release handle and pull it
slightly backwards.
Let go of the release handle.
#
The locks on the bench seat legs are
unlocked and red indicator tabs
housing of release handle
Hold the unlocked bench seat by grab han‐
#
dles 1 and pull backwards slightly.
Tilt bench seat 1 backwards and pull it out
#
of the mounting shells.
%
If the bench seat cannot be pulled out of the
mounting shells, the bench seat may be
wedged in the seat anchorage. This can hap‐
pen if the bench seat is tilted too far back‐
wards.
If the bench seat cannot be pulled out of the
mounting shells:
69
Seats and stowage
2 for the bench seat all
3 on the
2 are visible.