Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 70

68
Seats and stowage
Remove key 1 from the partition sliding
#
door.
Press the push button on catch
#
seat cushion 3 up or down.
Release push button
#
3 reaches its end position.
Move seat cushion 3
#
push button on catch
on the seat frame.
Installing and removing the rear bench seat
& WARNING Risk of injury if rear bench
seat is installed incorrectly
If you do not install the rear bench seat as
described, or install an unsuitable rear bench
seat, the seat belts may not provide the inten‐
ded protection.
Install the rear bench seat as described
#
and only in the direction of travel.
Installing the rear bench seat in the
#
opposite direction is not permitted.
Use only rear bench seats approved for
#
your vehicle by Mercedes-Benz.
& WARNING Risk of injury if rear bench
seat is not locked in place
If the locking mechanisms on the rear bench
seat legs are not correctly engaged, the rear
bench seat will not be held firmly and could
overturn during travel.
Ensure that the rear bench seat is
#
engaged before setting off. There must
2 and fold
2 when seat cushion
until it has locked. The
2 must be completely
be no red indicator tabs visible on the
release handle.
If red indicator tabs are visible on the
#
release handle, re-engage the rear
bench seat into place.
* NOTE Damage to rear bench seat rollers
caused by incorrect use
The rear bench seat rollers can be damaged if
the rear bench seat is used improperly or is
removed incorrectly.
As long as the rear bench seat is in the
#
mounting shells, do not pull these in the
direction of the rear doors. Roll the rear
bench seat only beside the mounting
shells.
Do not roll the rear bench seat when it
#
has been removed or use it as a means
of transport.
Warning on rear bench seat with correctly
installed rear bench seat shown.