Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 326

324
Wheels and tyres
To do this, use the flattened section on pump
#
lever 1 to turn pressure release screw
clockwise to the stop.
%
Do not turn pressure release screw
than one or two full turns. Hydraulic fluid
could otherwise escape.
Insert pump lever 1
#
the recess on the jack and secure by turning
it clockwise.
Place the jack vertically beneath the jacking
#
points described below.
Jacking point, front axle
Jacking point, rear axle (example: platform
vehicle up to 3.5 t)
3
3 more
with the largest rod into
Jacking point, rear axle (example: panel van
and crewbus up to 4.0 t)
Jacking point, rear axle (vehicles 5.0 t)
Place the jack beneath the jacking point in
#
front of the front axle.
Vehicles with all-wheel drive: unscrew jack
#
spindle 2 anti-clockwise as far as it will go.
Raise the vehicle until the tyre is raised a
#
maximum of 3 cm off the ground.
Loosen and remove the wheel (
#
Removing a wheel
Requirements:
The vehicle is raised (
R
When changing a wheel, avoid applying any
force to the brake discs since this could
impair the level of comfort when braking.
page 324).
→
page 322).
→