Work Mode - Mercedes-Benz Sprinter Operating Instructions Manual

If a loss of tyre pressure or a defective tyre
R
has been detected and displayed.
The system may be impaired or may not function
in the following situations:
There is poor visibility, e.g. due to insufficient
R
illumination of the road, highly variable shade
conditions, or due to rain, snow, fog or heavy
spray.
Dazzle from oncoming traffic, direct sunlight
R
or reflections.
There is dirt on the windscreen in the vicinity
R
of the multifunction camera or the camera is
misted up, damaged or obscured.
No or several, unclear lane markings are pres‐
R
ent for one lane, e.g. in a construction area.
The lane markings are worn, dark or covered.
R
The distance to the vehicle in front is too
R
small and the lane markings are thus not
detected.
The lane markings change quickly, e.g. lanes
R
branch off, cross one another or merge.
The carriageway is very narrow and winding.
R
Activating/deactivating Lane Keeping Assist
and Active Lane Keeping Assist
On-board computer:
Settings Assistance
, .
Depending on vehicle equipment, select
#
Spurhalte-Assistent
Assist) or Spurhalte-Assistent
Assist).
The driving system is activated or deactiva‐
ted, depending on its previous status.

Work mode

Activating/deactivating power take-off
Observe the following notes:
if there is severe strain on the power take-off,
R
e.g. due to a high power draw at high outside
temperatures, the transmission oil tempera‐
ture can increase to impermissible levels. In
this case, operate the power take-off at regu‐
lar intervals for about five to ten minutes
under a partial load.
only activate the power take-off when the
R
vehicle is stationary and the transmission is
in neutral position.
make sure that the engine speed is not higher
R
than 2500 rpm during operation.
Akt.
(Active Lane Keeping
(Lane Keeping
manual transmission is disabled in vehicles
R
with shift lock when the power take-off is
activated.
you can engage 1st or 2nd gear and drive
R
after activating power take-off in vehicles
without shift lock. Do not change gear while
the vehicle is in motion when power take-off
is activated. Therefore, pull away in 1st or
2nd gear depending on the desired speed.
observe the notes in the manufacturer's oper‐
R
ating instructions before using the power
take-off in conjunction with the body.
To activate: stop the vehicle and shift the
#
transmission to neutral.
depress the clutch pedal.
#
wait about five seconds and with the engine
#
running press the upper section of the switch
1.
release the clutch pedal.
#
On vehicles with a working speed governor
(ADR), the engine speed automatically increa‐
ses to a preset speed or a speed you have
set, the constant engine speed. The
speed governor active
active messages are shown in the multifunc‐
tion display.
To deactivate: stop the vehicle and shift the
#
transmission to neutral.
depress the clutch pedal.
#
wait about five seconds and with the engine
#
running press the lower section of the switch
2.
release the clutch pedal.
#
161
Driving and parking
Working
and Power take-off