Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 127

Press the brake pedal and the DIRECT
#
SELECT lever upwards or downwards to the
first point of resistance.
Transmission position display i is shown in
the multifunction display.
Releasing the brake pedal will allow you to move
the vehicle freely, e.g. to push it or tow it.
If the automatic transmission should also
stay in neutral i when the ignition is
switched off:
start the vehicle.
#
depress the brake pedal and shift to neutral
#
i.
release the brake pedal.
#
switch off the ignition.
#
%
if you then leave the vehicle and the key is
still in the vehicle, the automatic transmis‐
sion will stay in neutral i from then on.
Engaging park position P
Press button 1.
#
Transmission position display j is shown in
the multifunction display.
Park position j is engaged automatically when
one of the following conditions is met:
you switch off the engine in transmission
R
position h or k.
you open the driver's door when the vehicle is
R
stationary or when driving at a very low speed
and in transmission position h or k.
you open the seat belt buckle when the vehi‐
R
cle is stationary or when driving at a very low
speed.
you leave your seat when the vehicle is sta‐
R
tionary or when driving at a very low speed.
Engaging drive position D
Depress the brake pedal and push the
#
DIRECT SELECT lever downwards past the
first point of resistance.
Transmission position display h is shown in
the multifunction display.
The automatic transmission shifts through the
individual gears automatically when it is in trans‐
mission position h. This is determined by the
following factors:
the position of the accelerator pedal
R
the road speed
R
Restricting the shift range
Requirements:
transmission position h is engaged
R
( page 125).
→
125
Driving and parking