Changing Bulbs - Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual

These LEDs are classified under the 1M laser
class and can cause retina damage in the fol‐
lowing situations:
If you look directly into the unfiltered
R
laser beam from the motion detector for
an extended period
If you look directly into the laser beam of
R
the motion detector with optical instru‐
ments such as spectacles or a magnifying
glass.
Never look directly into the laser beam.
#
The motion detector is located in the cargo com‐
partment behind the partition in the middle of the
roof.
1
Position of motion detector
If the vehicle is equipped with a motion detector,
the cargo compartment lighting is also activated
via the motion detector.
If the motion detector detects movement in the
cargo compartment while the vehicle is station‐
ary, the cargo compartment lighting will switch
on for approximately two minutes.
The cargo compartment lighting can be switched
on via the motion detector if
the vehicle is stationary, the parking brake is
R
applied and you are not depressing the brake
pedal
in vehicles with automatic transmissions, the
R
selector lever is in position j and you are
not depressing the brake pedal
the vehicle has not been locked with the key
R
from the outside
If no change to the vehicle, such as a door open‐
ing, is detected over several hours, the motion
detector will automatically switch off. This pre‐
vents the battery from discharging.
Switching interior lighting delay time on/off
Multimedia system:
© Settings
, .
light shut-off
Switching the lighting delay time on and off.
#

Changing bulbs

Instructions for changing bulbs
& WARNING Risk of burns from hot com‐
ponent parts whilst replacing a bulb
Bulbs, lamps and plug connectors can
become very hot during operation.
When replacing a bulb, you could burn your‐
self on these component parts.
Allow the component parts to cool
#
down before replacing the bulbs.
Do not use any bulb that has been dropped or
R
has scratches on its glass tube. Otherwise,
the bulb may explode.
The bulb may explode if you touch it, if it is
R
hot, if you drop it or if you scratch it.
Stains on the glass tube reduce the bulb's
R
service life. Do not touch the glass tube with
your bare hands. If necessary, clean the glass
tube with alcohol or spirits in a cold state and
wipe it down with a lint-free cloth.
Protect bulbs from humidity and do not bring
R
them into contact with liquids.
Always ensure the bulbs are firmly secured.
If you vehicle is equipped with LED lamps, you
can check this as follows: the light cone will move
from top to bottom and back again when the
engine starts. For this to work, the dipped beam
needs to have been switched on before the
engine is started.
Bulbs and lights are a major element in vehicle
safety. Therefore, ensure that they are always
working. Have the headlamp setting checked reg‐
ularly.
Before changing the lamps, switch off the
R
vehicle's lighting system. You can thus avoid
a short circuit.
Use bulbs only in closed lights that have been
R
designed for them.
Use only spare bulbs of the same type and
R
with the correct voltage.
87
Light and vision
Lights Interior
. .