Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 72

70
Seats and stowage
Tilt the bench seat forwards without engaging
#
it.
Pull the bench seat backwards again using
#
release handle 2.
Tilt the bench seat backwards slightly and
#
pull it out of the mounting shells.
To remove or store the bench seat, place it
#
next to the mounting shells and roll it towards
the rear doors.
or
Lift the bench seat out from the side to store
#
it.
%
It may be necessary for the bench seats in
front or behind to be removed.
To attach the covers of the mounting
#
shells: hold cover 3
1 is pointing towards rear seat anchorage
2.
Insert cover 3 into the rear seat anchorage
#
2 by pushing it downwards at an angle and
then clip it to the mounting shell.
Installing the rear bench seat
Secure engagement of the rear bench seat is
guaranteed only if you keep the seat anchorages
clean and free of objects.
%
In vehicles registered as passenger vehicles,
observe the maximum permitted number of
seats.
Remove the covers of the mounting shells as
#
described under "Removing the rear bench
seat".
Position the bench seat behind the installa‐
#
tion position.
such that retaining lug
Hold the bench seat by the grab handles and
#
tilt it backwards.
Roll the bench seat forwards on the mounting
#
shells.
Ensure that the bench seat rear legs are
#
engaged.
Tilt the bench seat forwards firmly until the
#
locks on the bench seat front legs engage
audibly.
The locks on the bench seat front legs will
now be locked and the red indicator tabs on
the housing of release handle
longer be visible.
%
If the red indicator tabs on the release handle
housing are visible, the bench seat is not cor‐
rectly engaged.
If the bench seat is not correctly engaged:
Unlock the bench seat again and tilt it for‐
#
wards firmly until the locks on the bench seat
front legs engage audibly.
Attach the covers of the mounting shells as
#
described under "Removing the rear bench
seat".
1 should no