Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 163

%
The display contrast may be impaired by sud‐
den, incidental sunlight or other light sour‐
ces, e.g. when you are driving out of a
garage. In this case, pay particular attention.
%
Have the display repaired or replaced if, for
example, pixel errors considerably restrict its
use.
If the following conditions have been met, the
image from the 360° camera will automatically
be displayed in the multimedia system:
the ignition is switched on
R
the rear doors are opened
R
The area behind the vehicle can therefore be
monitored.
When the rear doors are closed, the image from
the reversing camera is switched off for approx‐
imately ten seconds.
See the notes on cleaning the 360° Camera
( page 279).
→
Selecting a view for the 360° Camera
Requirements:
The Auto reversing camera
R
multimedia system (
Engage reverse gear.
#
Select the desired view in the multimedia sys‐
#
tem.
Activating/deactivating automatic operation
of the reversing camera
The reversing camera is only an aid. It is not a
substitute for you paying attention to the sur‐
roundings. You are always responsible for safe
manoeuvring, parking and exiting of a parking
space. Make sure that no persons, animals or
objects etc. are in the path of your vehicle. Pay
attention to your surroundings and be ready to
brake at all times.
Multimedia system:
© Settings
, .
cle) Rear view camera
.
Activate or deactivate
#
Activating/deactivating manoeuvring assis‐
tance
Multimedia system:
© Settings
, .
tance Camera & Park. Assist
.
Activate or deactivate
#
is activated in the
page 161).
→
Fahrzeug (Vehi‐
.
Auto reversing camera.
Assis-
.
Manoeuvring assist..
%
When manoeuvring assistance is activated,
the following functions are active:
Drive Away Assist (
R
Rear Cross Traffic Alert (
R
ATTENTION ASSIST
Function of ATTENTION ASSIST
ATTENTION ASSIST assists you on long, monoto‐
nous journeys, e.g. on motorways and trunk
roads. If ATTENTION ASSIST detects indicators of
fatigue or increased lapses in concentration on
the part of the driver, it suggests taking a break.
ATTENTION ASSIST is only an aid. It cannot
always detect drowsiness or increased lapses in
concentration in good time. The system is not a
substitute for a well-rested and attentive driver.
On long journeys, take regular and timely breaks
that allow you to rest properly.
You can choose between two settings:
Standard: normal system sensitivity
R
Sensitive: higher system sensitivity. The
R
driver is warned earlier and the attention level
detected by the system (Attention Level) is
adapted accordingly.
If fatigue or increased lapses in concentration are
detected, the Attention Assist: Pause!
appears in the Instrument Display. You can
acknowledge the message and take a break if
necessary. If you do not take a break and ATTEN‐
TION ASSIST continues to detect increased lap‐
ses in concentration, you will be warned again
after a minimum of 15 minutes.
Display in the Instrument Display (colour display)
You can have the following status information for
ATTENTION ASSIST displayed in the Assistance
menu of the on-board computer:
the journey length since the last break
R
the attention level determined by ATTENTION
R
ASSIST:
161
Driving and parking
page 165)
→
page 165)
→
warning