Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 110

108
Climate control
Press the 1 or 3
#
for the day flashes.
Press the 4 button.
#
Use the 1 or 3 button to select the
#
required day of the week.
Press the 4 button.
#
Switching immediate heating mode on/off
To switch on: press button
#
flashes on menu bar 2.
On briefly appears on the display and then
the remaining operating duration or the à
symbol for continuous operation.
To switch on: press button
#
appears on the display.
Setting the departure time
You can set three departure times with the switch
clock. Following malfunctions or if the battery
has been disconnected, you will need to re-set
the departure times.
To set the departure time: press the
#
3 button until j flashes on the
row.
Press the 4 button.
#
The numbers of the program memories are
shown in the program column 5. The tick
denotes activated program memories.
Problems with the auxiliary warm-air heater
Problem
The message ERROR
appears on the switch
clock's display.
The message INIT
appears on the switch
clock's display.
Auxiliary heating auto‐
matically switches off
and/or cannot be
switched on.
button until the symbol
4 until y
4 until Off
1 or
2 menu
Possible causes/consequences and
A malfunction has occurred.
Have the auxiliary heating checked at a qualified specialist work‐
#
shop.
The power supply has been interrupted. All saved settings have been
deleted.
Automatic hardware detection is currently active.
When automatic hardware detection is complete, set the day of the
#
week, time and operating duration (
Set the departure time (
#
The low-voltage protection system integrated in the control unit switches
auxiliary heating off as the on-board voltage is below 10 V.
Have the generator and the battery checked.
#
The electrical fuse has blown.
Replace the electrical fuse; see "Fuse assignment" supplement.
#
Use the 1 or 3 button to select the
#
required program memory.
Press the 4 button.
#
To activate/deactivate program memo‐
#
ries: use the 1 or
Off.
Press button 4.
#
To edit the program memory: use the
#
3 button to select 4.
Press the 4 button.
#
Set the day of the week and the time
#
( page 107).
→
Setting the temperature and operating dura‐
tion
Press the 4 button.
#
Set the temperature with button
#
Press the 4 button.
#
Set the operating duration with button
#
3 or select the à symbol for continuous
operation.
Press the 4 button.
#
%
The operating duration set is the default set‐
ting for immediate heating mode. You can set
the operating duration within a range of 10 to
120 minutes or to continuous operation.
Solutions
M
page 107).
→
page 108).
→
3 button to select On
1
1 or 3.
1 or
or
or