Work Before Handing Over The Modified Vehicle; Special Equipment; Adhesive Films On The Vehicle Exterior - Mercedes-Benz eSprinter 907 Series 2024 Supplemental Manual

3 Planning of bodies
⑴ NOTE
Do not disconnect the 12 V battery, even in the
event of lengthy non-operational time. Otherwise,
the vehicle cannot monitor the state of charge of the
high-voltage battery.
Please refer to the further information and specifica-
tions in the Operator's Manual of your vehicle.
Safety note for the high-voltage battery
Have all work on the high-voltage battery carried out at
a qualified specialist workshop.
Observe the information on the high-voltage on-board
electrical system (→ page 10) and instructions on
the 12 V battery in the Body-Equipment-Guideline for
Sprinter Vans.
⚠ WARNING
If the housing of the high-voltage battery is damaged,
electrolyte and gases can escape. These are toxic
and corrosive.
There is danger to life and limb!
Avoid all contact with your skin, eyes, or clothing.
Rinse off splashes of electrolyte immediately with
water and seek medical assistance without delay.
3.11.3 Work before handing over the modified
vehicle
ⓘ
You can find information on this topic in the chapter
of the same name in the Body-Equipment-Guideline
for Sprinter Vans.
30 Mercedes-Benz | Supplemental Guideline for eSprinter – Model Series 907, Edition 2023-8
3.12

Special equipment

ⓘ You can find information on this topic in the chapter
of the same name in the Body-Equipment-Guideline
for Sprinter Vans.
3.13

Adhesive films on the vehicle exterior

ⓘ
You can find information on this topic in the chapter
of the same name in the Body-Equipment-Guideline
for Sprinter Vans.