Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 277

Turn coolant expansion reservoir cap
#
ther and remove it.
Check the coolant level.
#
There is enough coolant in coolant expansion
reservoir if the coolant reaches the MAX
mark.
Topping up the coolant
Refill the coolant to the MAX mark on the
#
coolant expansion reservoir.
Only use coolant approved by Mercedes-Benz to
avoid damaging the engine cooling system.
Replace coolant expansion reservoir cap
#
and tighten in a clockwise direction.
Start the engine.
#
After approximately five minutes, switch off
#
the engine again and allow it to cool down.
Check the coolant level again and top up the
#
coolant if necessary.
%
Further information on coolant (
Filling up the windscreen washer system
& WARNING Danger of burns from hot
component parts in the engine compart‐
ment
Certain component parts in the engine com‐
partment may be very hot, e.g. the engine,
the radiator and parts of the exhaust system.
Let the engine cool down and only
#
touch the component parts described
below:
If you have to carry out any work in the engine
compartment, touch only the following compo‐
nents:
bonnet
R
engine oil filler opening cap
R
washer fluid reservoir cap
R
coolant expansion tank cap
R
& WARNING Danger of burns when open‐
ing the bonnet
If you open the engine bonnet when the
engine has overheated or during a fire in the
engine compartment, you could come into
contact with hot gases or other escaping
operating fluids.
1 fur‐
#
#
& WARNING ‑ Risk of fire and injury due to
Windscreen washer concentrate is highly
flammable. It could ignite if it comes into con‐
tact with hot engine component parts or the
exhaust system.
1
#
Topping up the washer fluid
page 340)
→
Washer fluid reservoir (example)
Pre-mix the washer fluid in the correct mixing
#
ratio in a container.
Park the vehicle on a level surface and secure
#
it against rolling away (
Open the bonnet (
#
Pull the cap of washer fluid container
#
upwards by the strap.
Pour in the pre-mixed washer fluid.
#
Press cap
#
audibly engages.
Close the bonnet (
#
Further information about the windscreen
R
washer fluid (
Maintenance and care
Before opening the bonnet, allow the
engine to cool down.
In the event of a fire in the engine com‐
partment, keep the engine bonnet
closed and call the fire service.
windscreen washer concentrate
Make sure that no windscreen washer
concentrate spills out next to the filler
opening.
→
page 270).
→
1 onto the filler opening until it
page 270).
→
page 340)
→
275
page 140).
1