Work Mode - Mercedes-Benz Sprinter 2018 Operating Instructions Manual

174 Driving and parking
You switch on the turn signal.
R
A driving safety system intervenes, such as
R
®
ESP or Active Brake Assist.
You have adopted a sporty driving style with
R
high cornering speeds or high rates of accel‐
eration.
®
ESP has been switched off.
R
When driving with a trailer, the electrical con‐
R
nection to the trailer has been correctly
established.
If a loss of tyre pressure or a defective tyre
R
has been detected and displayed.
The system may be impaired or may not function
in the following situations:
There is poor visibility, e.g. due to insufficient
R
illumination of the road, highly variable shade
conditions, or due to rain, snow, fog or heavy
spray.
Dazzle from oncoming traffic, direct sunlight
R
or reflections.
There is dirt on the windscreen in the vicinity
R
of the multifunction camera or the camera is
misted up, damaged or obscured.
No or several, unclear lane markings are pres‐
R
ent for one lane, e.g. in a construction area.
The lane markings are worn, dark or covered.
R
The distance to the vehicle in front is too
R
small, and therefore the lane markings cannot
be detected.
The lane markings change quickly, e.g. lanes
R
branch off, cross one another or merge.
The carriageway is very narrow and winding.
R
Activating/deactivating Lane Keeping Assist
or Active Lane Keeping Assist
Multimedia system:
© Settings
4 5
Select Lane Keeping Assist
#
Keep. Asst On.
Activating or deactivating warning
Select Lane Keeping Assist
#
Keep. Asst On.
Select Warning.
#

Work mode

Activating/deactivating power take-off
Observe the following notes:
Assistance
5
or Act. Lane
or Act. Lane
if there is severe strain on the power take-off,
R
e.g. due to a high power draw at high outside
temperatures, the transmission oil tempera‐
ture can increase to impermissible levels. In
this case, operate the power take-off at regu‐
lar intervals for about five to ten minutes
under a partial load.
only activate the power take-off when the
R
vehicle is stationary and the transmission is
in neutral position.
make sure that the engine speed is not higher
R
than 2500 rpm during operation.
manual transmission is disabled in vehicles
R
with shift lock when the power take-off is
activated.
you can engage 1st or 2nd gear and drive
R
after activating power take-off in vehicles
without shift lock. Do not change gear while
the vehicle is in motion when power take-off
is activated. Therefore, pull away in 1st or
2nd gear depending on the desired speed.
observe the notes in the manufacturer's oper‐
R
ating instructions before using the power
take-off in conjunction with the body.
To activate: stop the vehicle and shift the
#
transmission to neutral.
depress the clutch pedal.
#
wait about five seconds and with the engine
#
running press the upper section of the switch
1.
release the clutch pedal.
#
On vehicles with a working speed governor
(ADR), the engine speed automatically increa‐
ses to a preset speed or a speed you have
set, the constant engine speed. The
speed governor active
Working
and Power-take off