Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 76

74
Seats and stowage
If you are using a roof rack, please note the maxi‐
mum roof load and the maximum load capacity of
the roof rack.
You will find information about the maximum roof
load in the "Technical data" chapter and informa‐
tion about roof racks in the "Carrier systems"
section .
Camera-based driving systems and the sensor
functions of the inside rearview mirror may be
impaired if you are transporting a load on the
roof and it protrudes more than 40 cm over the
edge of the roof. Therefore, make sure that the
load does not overhang by more than 40 cm.
The handling characteristics of your vehicle are
dependent on the load distribution. Therefore,
please observe the following notes when loading:
when transporting a load, never exceed the
R
permissible gross mass or the permissible
axle loads for the vehicle (including occu‐
pants).
the load must not protrude above the upper
R
edge of the seat backrests.
if possible, always transport the load in the
R
load compartment.
fasten the load to the tie-down eyes and
R
spread the load as evenly as possible.
use tie-down eyes and fastening components
R
which are suitable for the weight and size of
the load.
Overview of the front stowage compartments
Overview of the front stowage compartments
Observe the notes on loading the vehicle
( page 73).
→
1
Lockable compartment above windscreen
( page 75)
→
2
Windscreen stowage compartment with two
cupholders / ashtray stowage space
Stowage compartment with cover, depending
on specification (
→
3
Centre console stowage compartment with
USB connection, charging interface, NFC
interface and 12-V socket
4
Stowage compartment above windscreen
(subject to a maximum load of 2.5 kg)
5
Front passenger stowage compartment (sub‐
ject to a maximum load of 5 kg)
6
Cup holder
7
Stowage compartment in the doors
Centre console stowage compartment /
opening and closing the windscreen
Stowage compartment cover (example: centre
console)
page 74)