Anti-Theft Protection - Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual

Problem
The side windows cannot
be opened or closed
using the convenience
opening feature.

Anti-theft protection

Function of immobiliser
The immobiliser prevents your vehicle from being
started without the correct key.
The immobiliser is automatically activated when
the ignition is switched off, and deactivated when
the ignition is switched on.
ATA (Anti-Theft Alarm system)
Function of ATA (Anti-Theft Alarm system)
If the ATA system is primed, a visual and audible
alarm is triggered in the following situations:
a side door is opened
R
the rear door is opened
R
the bonnet is opened
R
the interior motion sensor is triggered
R
( page 59)
→
tow-away protection is triggered
R
( page 58)
→
Possible causes/consequences and
& WARNING Risk of becoming trapped or fatally injured if revers‐
ing protection is not activated
If you close a side window again immediately after it has been
blocked or reset, the side window closes with increased or maximum
force. The reversing feature is then not active.
Parts of the body could become trapped in the closing area in the
process.
Make sure that no parts of the body are in the closing area.
#
To stop the closing process, release the button or press the
#
button again to reopen the side window.
If a side window is obstructed during closing and reopens again slightly:
Immediately after the window gets stuck, pull the corresponding but‐
#
ton again until the side window has closed, and hold the button for
an additional second.
The side window is closed with increased force.
If a side window is obstructed again and reopens again slightly:
Repeat the previous step.
#
The side window is closed without the automatic reversing function.
the key battery is weak or discharged
Check the battery with the battery indicator lamp and replace if nec‐
#
essary( page 42).
→
Solutions
M
ATA is automatically switched on after approx‐
imately five seconds:
after the vehicle has been locked with the key
R
When the ATA system is primed, indicator lamp
1 flashes in the overhead control panel.
ATA is automatically switched off:
After unlocking the vehicle with the key.
R
After pressing the start/stop button with the
R
key inside the vehicle.
Opening and closing
57