Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 333

Place a screwdriver into recesses
#
then prise off covers 1.
Using the wheel wrench from the vehicle tool
#
kit, unscrew the now visible bolts anti-clock‐
wise by approximately 20 turns.
Slightly raise spare wheel carrier
#
unhook left-hand safety hook 3.
Assemble the pump lever for the jack and
#
slide it into sleeve 5
of spare wheel carrier 4.
Raise the spare wheel carrier with the pump
#
lever and unhook right-hand safety hook 3.
Position loop 7 of extraction device
#
the spare wheel so that you will later be able
to attach wheel wrench 8.
Prepare the jack.
#
Place the jack beneath the corresponding
#
jack support point.
Move the pump lever up and down until the
#
tyre is raised a maximum of 3 cm off the
ground.
Hook wheel wrench
#
extraction device 6
Carefully remove the spare wheel from spare
#
wheel carrier 4. The spare wheel is heavy.
When the spare wheel is removed, the centre
of gravity changes due to the heavy weight of
the wheel. The spare wheel may slip down or
tip over.
Remove the spare wheel extraction device
#
and store it in a safe place. You can now fit
the spare wheel to your vehicle.
Lower the vehicle.
#
Vehicles with rear wheel drive: fitting the
spare wheel (vehicle with lowered chassis)
% In the event of a flat tyre, you may store the
defective wheel inside the vehicle only. An
intact wheel may be stored in the spare
wheel carrier only when the vehicle is unla‐
den. A laden vehicle must first be raised.
Carefully place the spare wheel onto spare
#
wheel carrier 4. The spare wheel is heavy.
When you place the spare wheel onto spare
wheel carrier 4, the centre of gravity
changes due to the weight of the wheel. The
spare wheel may slip down or tip over.
Slide the pump lever for the jack into sleeve
#
5 on spare wheel carrier 4.
2 and
4 and
on the right-hand side
6 on
8 into loop 7 of
on the spare wheel.
Raise spare wheel carrier
#
lever and attach right-hand safety hook 3.
Slightly raise spare wheel carrier
#
attach left-hand safety hook 3.
Pull the pump lever out of sleeve 5.
#
Using the wheel wrench, tighten safety hook
#
bolts 3 by turning them clockwise.
Replace and engage covers 1.
#
Close the rear-end doors.
#
Removing the spare wheel in the load com‐
partment
Release clamping strap
#
ratchet.
Carefully remove the spare wheel from
#
bracket 2.
Fitting the spare wheel in the load compart‐
ment
Place the spare wheel in bracket
#
press it onto the wall.
Tighten clamping strap
#
331
Wheels and tyres
4 with the pump
4 and
1 by opening the
2 and
1 with the ratchet.