Range Of Functions Of The Wbm - Siemens Simatic RTU303xC Series Operating Instructions Manual

Configuration (WBM)

4.2 Range of functions of the WBM

These can be:
● TeleControl Basic / 55097 * (TCP)
● ST7 / 26382 * (TCP)
● FTP / 21 * (TCP) (and dynamically decided by the server, passive mode)
● DHCP / 67, 68 (UDP) (only LAN)
● NTP / 123 (UDP)
● SMTP / 25 * (TCP) (LAN and WAN)
● DNS / 53 (UDP) (LAN and WAN)
● DynDNS / 443 (TCP) (only WAN)
● SINEMA RC Autoconfiguration / 443 * (TCP) (LAN and WAN)
● SINEMA RC and OpenVPN / 1194 * (UDP) (LAN and WAN)
● Syslog / 514 * (UDP)
* The port number can be set in WBM.
4.2 Range of functions of the WBM
Web Based Management (WBM)
The RTU is configured using the Web Based Management (WBM) of the RTU.
The WBM consists of integrated Web pages of the RTU that can be called up in the Web
browser of a connected configuration PC.
For information on the Web browsers that can be used on the configuration PC, see section
Scope of delivery, accessories, requirements (Page 39).
Overview of the functions of the WBM
With the WBM, the following functions are available to you:
User management
Via HTTP/HTTPS you connect to the RTU from a configuration PC.
In the open WBM of the RTU, you specify individual users that may access the WBM of the
RTU with a user name and password.
Configuration functions
Using the WBM, configure the following functions of the RTU:
● Device-internal functions, such as the time of day or IP address
● Settings of the operating modes of the RTU
● Inputs and outputs of the sensors and actuators connected to the RTU
92
Operating Instructions, 06/2019, C79000-G8976-C382-06
RTU303xC