Operating Instructions, 06/2019, C79000-G8976-C382 - Siemens Simatic RTU303xC Series Operating Instructions Manual

Preface
● Central logging of security and audit events; sending of events via the Syslog protocol.
● DNP3 redundancy
● Revision of function block "Silo volume calculation"
● Increase in configuration limits for function blocks
● Editorial revision
For the product notices on the Internet see:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/21767/pm)
Replaced edition
Edition 07/2018
Current manual release on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/21767/man)
Cross references
In this manual there are often cross references to other sections.
To be able to return to the initial page after jumping to a cross reference, some PDF readers
support the command <Alt>+<left arrow>.
Sources of information and other documentation
You will find an overview of further reading and references in the Appendix of this manual.
License conditions
Note
Open source software
Read the license conditions for open source software carefully before using the product.
You will find the license conditions as a loadable file on the WBM pages of the device. You
will find the description of opening and loading license conditions in section General
functions of the WBM (Page 94).
You will find the packed file with the license conditions for Open Source software under the
following name:
● OSS_RTU30xxC_86.zip
6

Operating Instructions, 06/2019, C79000-G8976-C382-06

RTU303xC