Wake-Up Call / Wake-Up Sms - Siemens Simatic RTU303xC Series Operating Instructions Manual

Configuration (WBM)
4.23 Telecontrol
Status IDs - DNP3
The status IDs correspond to the following elements of the specification:
OBJECT FLAGS - DNP3 Specification, Volume 6, Data Object Library-Part 1
Table 4- 9 DNP3: Bit assignment of the status byte for DNP3 data points
Bit 7
Flag name -
Meaning -
not sup-
Bit status
ported
(always 0)
Status IDs - IEC
The status IDs correspond to the following elements of the specification:
Quality descriptor - IEC 60870 Part 5-101
Table 4- 10 IEC: Bit assignment of the status byte for IEC data points
Bit 7
Flag name -
Meaning -
not sup-
Bit status
ported
(always 0)
4.23.8

Wake-up call / wake-up SMS

Waking the RTU from sleep mode
The RTU can be woken out of the sleep mode with a wake-up call from a mobile phone.
When using the communications protocol "TeleControl Basic", the RTU can also be woken
by a wake-up SMS message that can be generated by TCSB. For other communications
protocols the SINEMA Remote Connect server can also send a wake-up SMS message.
240
6 5
- -
- -
not sup- not sup-
ported ported
(always 0) (always 0)
6 5
- SB
substituted
- Substitute
value
not sup- not sup-
ported ported
(always 0) (always 0)
4 3
LOCAL_ DISCONTI
FORCED NUITY
Local oper- Counted
ator control value over-
flow before
reading the
value
not sup- not sup-
ported ported
(always 0) (always 0)
4 3
- CY
carry
- Counted
value-
overflow
before
reading the
value
not sup- not sup-
ported ported
(always 0) (always 0)
Operating Instructions, 06/2019, C79000-G8976-C382-06
2 1
OVER_ RESTART
RANGE
Value Value not
range ex- updated
ceeded, after start
analog
value
1 1
2 1
OV NT
overflow not topical
Value - Value not
range ex- updated
ceeded,
analog
value
1 1
0
ONLINE
Value is
invalid
1
0
IV
invalid
Value is
invalid
0
RTU303xC