Siemens Simatic RTU303xC Series Operating Instructions Manual page 5

The manaul supports you when installing, connecting up and commissioning the device.
The required configuration steps for the device are described.
You will also find instructions for operation and information about the diagnostics options.
Required experience
To install, commission and operate the device, you require experience in the following areas:
● General electrical engineering
● Automation engineering
● Data transfer via mobile wireless networks and Internet
Abbreviations/acronyms
This manual often uses the following abbreviations/acronyms:
● RTU
The name "RTU" (Remote Terminal Unit) is used instead of the full product names
"RTU3010C", "RTU3030C" and "RTU3031C".
● RTU30x0C
Used as a substitute for the complete product names of the "RTU3010C" and
"RTU3030C" devices.
● RTU303xC
Used as a substitute for the complete product names of the "RTU3030C" and
"RTU3031C" devices.
● HW2
Stands for devices with hardware product version 2.
● WBM
"WBM" the acronym for the "Web Based Management" of the Web pages of the RTU for
configuration and diagnostics data.
● Extension board
The term "extension board" is used instead of the full product name "EXTENSION
BOARD HART / RS485".
● TCSB
Acronym for the control center software "TeleControl Server Basic" which is installed on a
PC, the telecontrol server.
New in this release
● Connection from up to 8 Hart devices through the expansion card "EXTENSION BOARD
HART / RS485"
● Remote access for SIMATIC PDM to HART and Modbus devices via HART-IP or Modbus
TCP
RTU303xC
Operating Instructions, 06/2019, C79000-G8976-C382-06
Preface
5