Siemens Simatic RTU303xC Series Operating Instructions Manual page 346

Approvals
cULus
Underwriters Laboratories Inc. meets
● Underwriters Laboratories, Inc.: UL 61010-1 (Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use - Part 1: General
Requirements)
● IEC/UL 61010-2-201 (Safety requirements for electrical equipment for measurement,
control and laboratory use. Particular requirements for control equipment)
● Canadian Standards Association: CSA C22.2 No. 61010-1-12 / CSA-IEC 61010-2-201
cULus HAZ.LOC.
Underwriters Laboratories Inc. meets
● ISA 12.12.01 (Nonincendive Electrical Equipment for Use in Class I and II, Division 2 and
Class III, Divisions 1 and 2 Hazardous (Classified) Locations)
● CSA C22.2 No. 213 (Hazardous Location)
APPROVED for Use in:
● Cl. 1, Div. 2, GP. A, B, C, D T4; Ta = -40 °C...+70 °C
● Cl. 1, Zone 2, GP. IIC T4; Ta = -40 °C...+70 °C
FM
Factory Mutual Research (FM)
Approval standard class number 3600 and 3611
Approved for use in:
● Class I, Division 2, Group A, B, C, D, Temperature Class T4, Ta = 70 °C
● Class I, Zone 2, Group IIC, Temperature Class T4, Ta = 70 °C
RCM
The RTU meets the requirements of the AS/NZS 2064 standards (Class A).
National wireless approvals
To operate the device in certain countries approvals for wireless operation must exist, the
agreed marking must be present on the type plate and special instructions for the particular
country must be adhered to. Some of the national approvals and instructions are shown
below.
346
Operating Instructions, 06/2019, C79000-G8976-C382-06
RTU303xC