Configuration (WBM)
4.13 LAN
Use of the logging
You should only use logging of events. If you have problems with the RTU that you cannot
solve yourself.
Note
Protecting the SD card by disabling logging
To avoid shortening the working life of the SD card too much, logging should be disabled
during normal operation of the RTU.
When logging is enabled, during runtime the RTU continuously saves information about
important events that have occurred. The saved data contains information on the
configuration, active procedures and error situations.
The data is saved on the SD card in a log file with the name "support.bin". The information in
this file is encrypted and can only be read by Siemens Industry Online Support. On
completion of logging sent the log file back to your contact at Siemens Industry Online
Support.
4.13
LAN
4.13.1
Overview
In this tab you will find the most important data of the Ethernet interface:
● MAC address
● Connection status
Connection status to the Ethernet network
● Transmission properties
Transmission speed and direction dependency (default: 100 Mbps, full duplex)
● Connected since (dd:hh:mm:ss)
● Own IP address
Shows the preset, last configured or the last IP address to be obtained from the DHCP
server.
● Subnet mask
Shows the preset, last configured or the last subnet mask to be obtained from the DHCP
server.
130
Operating Instructions, 06/2019, C79000-G8976-C382-06
RTU303xC