Best E5 Series User Manual page 97

E5 User Manual
Time of initial segment of
P12.17
Decel S-curve
Time of last segment of
P12.18
Decel S-curve
These four parameters are enabled when P12.12 is set to 2.
Proportion of initial
P12.19
segment of Accel S-curve
Proportion of last segment
P12.20
of Accel S-curve
Proportion of initial
P12.21
segment of Decel S-curve
Proportion of last segment
P12.22
of Decel S-curve
These four parameters are enabled when P12.12 is set to 3.
 ATTENTION:
The sum of set values of P12.19 and P12.20 should not exceed 100.0%. The same to
P12.21 and P12.22.
Group P20 Digital Input
Enabled condition of run
P20.00 command terminals when
This parameter is only for digital terminals with parameter value 1~4 (forward/reverse jog, and
forward/reverse running), and also is only for initial running after power up.
0: Trigger edge detected + ON detected
When run command is controlled by terminals, the drive will start to run when it detects that
the terminal jumps from OFF to ON and is kept ON after power up.
If run command terminal is in ON state before power up, the drive will not run after
power up. Under this circumstance, only when the ON state is shifted to OFF and then ON
again, and maintain ON, the drive will start running.
1: ON detected
When run command is controlled by terminals, the drive will start to run when detecting the
command terminal at ON state after power up.
 ATTENTION:
When "1: ON detected" selected, the drive will start to run after power up as long as ON of run
command terminal detected. Make sure of the safety of personnel and equipment before this
setting.
power up
Range: 0.00s~60.00s
Range: 0.00s~60.00s
Range: 0.0%~100.0%
Range: 0.0%~100.0%
Range: 0.0%~100.0%
Range: 0.0%~100.0%
Range: 0~1
- 93 -
Chapter 5 Specification of Parameters
Factory default: 0.20s
Factory default: 0.20s
Factory default: 20.0%
Factory default: 20.0%
Factory default: 20.0%
Factory default: 20.0%
Factory default: 0