Best E5 Series User Manual page 117

E5 User Manual
Group P22 Analog and Pulse Input
P22.00
Curves of analog input AI1, AI2 and EAI are selected by this parameter.
 Unit's place: AI1 input curve
0: Curve 1 (2 points)
Defined by P22.01~P22.04.
1: Curve 2 (4 points)
Defined by P22.05~P22.12.
2: curve 3 (4 points)
Defined by P22.13~P22.20.
 Decade: AI2 input curve
Same as specification of AI1.
 Hundreds place: Reserved
Same as specification of AI1.
P22.01 Maximum input of curve 1
Set value corresponding to
P22.02
maximum input of curve 1
P22.03 Minimum input of curve 1
Set value corresponding to
P22.04
minimum input of curve 1
Curve 1 is defined by above-noted 4 parameters.
Input values P22.01 and P22.03:
AI1~AI2 are 0~10V or 0~20mA programmable by jumper on control board.
If 0~10V is selected: 0V corresponds to 0%, while 10V corresponds to 100%.
If 0~20mA is selected: 0mA corresponds to 0%, while 20mA corresponds to 100%.
Corresponding set values P22.02 and P22.04:
When the corresponding set value is frequency: 100% is the maximum frequency, while
-100% is the maximum negative frequency.
When the corresponding set value is current: 100% means 2 times the rated current of
drive while "less than or equal to 0%" corresponds to zero current.
When corresponding set value is torque: 100% means 2 times the rated torque, while -100%
means negative "2 times the rated torque".
When the corresponding set value is output voltage (e.g. the voltage setting in case of V/f
separated pattern): 100% corresponds to rated voltage of motor. "Less than or equal to 0%"
corresponds to 0V voltage.
Analog input curve Range: 000~222
Range: minimum input of curve
1 ~110.0%
Range: -100.0%~100.0%
Range: -110.0%~maximum
input of curve 1
Range: -100.0%~100.0%
- 113 -
Chapter 5 Specification of Parameters
Factory default: 000
Factory default:
100.0%
Factory default:
100.0%
Factory default:
0.0%
Factory default:
0.0%