Best E5 Series User Manual page 66

Chapter 4 List of Parameters
Param. Designation
LED displayed
P71.01 parameters setting 2 on
running status
LED displayed
P71.02 parameters setting on
stop status
Scope
BIT3: Reserved
Note: when this parameter is set to
0000, running frequency (Hz)
would be displayed as default
Setting of binary system:
0: Display disabled
1: Display enabled
Unit's place:
BIT0: Running linear speed (m/s)
BIT1: Set linear speed (m/s)
BIT2: Input terminal status
BIT3: Output terminal status
Decade:
BIT0: PID setting (%)
BIT1: PID feedback (%)
BIT2: Set length (m)
BIT3: Actual length (m)
Hundreds place:
BIT0: Setting torque
BIT1: Reserved
BIT2: Reserved
BIT3: Reserved
Thousands place :Reserved
Setting of binary system:
0: Display disabled
1: Display enabled
Unit's place:
BIT0: Command frequency (Hz)
BIT1: Bus voltage (V)
BIT2: Input terminal status
BIT3: Output terminal status
Decade:
BIT0: AI1 (V)
BIT1: AI2 (V)
BIT2: Reserved
BIT3: Reserved
Hundreds place:
BIT0: PID setting (%)
BIT1: PID feedback (%)
BIT2: Set length (m)
BIT3: Actual length (m)
Thousands place:
- 62 -
E5 User Manual
Factory
Attr
Default
○
0000
○
0003