Best E5 Series User Manual page 106

Chapter 5 Specification of Parameters
command frequency with the set ramp up time.
 ATTENTION:
When this terminal is enabled, output frequency does not need to decelerate to brake start
frequency, but will directly inject DC whose value is set by P11.15.
70~99: Reserved
Filtering time of digital
P20.11
input terminal
Set the filtering time of X1~X6 (when X6 is used as ordinary low-speed terminal), AI1, AI2 and
RESERVED (when used as digital input terminal). Interference immunity of digital input
terminals can be improved by appropriate filtering time. However, the response time of digital
input terminal will become slower when filtering time is increased.
 ATTENTION:
This filtering time takes no effect on X6/DI when X6/DI terminal is used as DI high-speed
input terminal, while the filtering time of DI is determined by parameter P22.28.
P20.12 Delay time of terminal X1
P20.13 Delay time of terminal X2
The delayed response time of digital input terminals X1 and X2 is set by these two parameters.
 ATTENTION:
Terminal delay time P20.12 and P20.13 can be set with filtering time P20.11 at the same
time. The drive will respond after the signals via X1 and X2 go through filtering time, and
then delay time. Terminals X3~X6 and EX have no delay time function.
Digital input terminal enabled
P20.14
 Unit's place: X1
0: Positive logic; ON when current passes through
1: Negative logic; ON when no current passes through
 Decade: X2 (same as X1)
 Hundreds place: X3 (same as X1)
 Thousands place: X4 (same as X1)
Digital input terminal
P20.15
enabled status setting 2
 Unit's place: X5
status setting 1
Range: 0.000s~1.000s
Range: 0.0s~3600.0s
Range: 0.0s~3600.0s
Range: 0000~1111
Range: 000~111
- 102 -
E5 User Manual
Factory default:
0.010s
Factory default:
0.0s
Factory default:
0.0s
Factory default:
0000
Factory default:
000