Chapter 5 Specification Of Parameters - Best E5 Series User Manual

E5 User Manual

Chapter 5 Specification of Parameters

Group P00 System Parameters
P00.00 Setting of user password
Setting of password:
A non-zero four-digital number could be set as a user password by entering this password into
P00.00 and pressing ENT key to confirm once, then reenter and reconfirm it once again within
10 seconds. Once this password has been successfully set, the word "P-SEt" would be
displayed. The password setting will take effect as long as there is no operation on keypad
within 5 minutes, or cutting the power off and power up again .
Change password:
Access P00.00 after entering the original four-digit password (at this point, P00.00 displays
0000) and set the new password following the above-noted procedure.
Password clearance:
Access P00.00 after entering the original four-digit password (at this point, P00.00 displays
0000), enter 0000 twice and press ENT key to make confirmation. In this way, password is
successfully cleared and the word "P-CLr" is displayed.
P00.01 Display of parameters
This parameter sets the display/hide of parameters.
0: Display all parameters
1: Only display parameters P00.00 and P00.01
2: Reserved
3: Only display P00.00, P00.01, and the parameters different with factory default
P00.02 Parameter protection
0: All parameter programming allowed
1: Only P00.00 and this parameter programming allowed
When this parameter is set to 1, all parameters other than P00.00 and P00.02 are not allowed
to modify. Set P00.02 to 0 before the modification of other parameters.
P00.03 Parameter initialization
0: No operation
1: Clear fault record1: When this parameter is set to 1, all fault record of Group P81 will be
Chapter 5 Specification of Parameters
Range: 0~FFFF
Range: 0~3
Range: 0~1
Range: 0~4
- 71 -
Factory default:
0000
Factory default:
0
Factory default:
0
Factory default:
0