Best E5 Series User Manual page 82

Chapter 5 Specification of Parameters
When selecting AI1 as auxiliary frequency command source (set P10.03 to 3) and setting AI1 to
curve 1 (unit's place of P22.00 is 0), the frequency that corresponds to maximum input of curve
1 should be: (P22.02) ● [master frequency ● (P10.06)].
When X6/DI pulse input is selected as auxiliary frequency command source (set P10.03 to
6), the frequency that corresponds to maximum DI input should be: (P22.25) ● [master
frequency ● (P10.06)].
When PID is selected for auxiliary frequency command, the frequency that corresponds to
maximum value of PID output should be [master frequency ● (P10.06)].
PID output diagram is as shown in Fig.5-3.
Computation of master
P10.07
and auxiliary frequency
0: Master + auxiliary
The sum of master and auxiliary frequency is taken as frequency command. Output result is
subject to limitation of upper and lower limit frequency.
1: Master - auxiliary
The difference between master and auxiliary frequency is taken as frequency command.
Output result is subject to limitation of upper and lower limit frequency.
2: Max {master, auxiliary}
Master frequency or auxiliary frequency (whichever has a larger absolute value) is taken as
frequency command. Output result is subject to limitation of upper and lower limit frequency.
3: Min {master, auxiliary}
Master frequency or auxiliary frequency (whichever has a smaller absolute value) is taken as
frequency command. Output result is subject to limitation of upper and lower limit frequency.
P10.08 Maximum frequency
P10.09 Upper limit frequency
P10.10 Lower limit frequency
Frequency output
频率输出
Master command 主给定值×(b0-06)
value × (P10.06)
0
0
Fig. 5-3
Range: Upper limit frequency
~600.00Hz
Range: Lower limit frequency ~
maximum frequency
Range: 0.00Hz ~ upper limit
frequency
PID output
PID输出
最大值
Maximum value
Range: 0~3
- 78 -
E5 User Manual
Factory default: 0
Factory default:
50.00Hz
Factory default:
50.00Hz
Factory default:
0.00Hz