Table of Contents
Advertisement
CDM-750 Advanced High-Speed Trunking Modem
Front Panel Operation
5.2.5.5
Info: Clocks
REF=Internal+O/P
This screen shows the Frequency Reference as configured using the CONFIG: Clocking → Freq‐Ref
menu.
5.2.5.6
Info: ACM
Tx ModCod=QPSK 3/4
Rx ModCod=QPSK 3/4
This screen shows the current ACM operating parameters (when enabled).
5.2.5.7
Info: CnC
CnC-Status:
This screen shows the current CnC operating parameters (when enabled).
5.2.5.8
Info: Misc
1:1 Redundancy Status: Online
1:1 Switch=Connected Link=Good
This screen provides the following information.
On the Top line: 1:1 Redundancy Status = Offline or Online.
On the Bottom line:
•
1:1 Switch – The connection status is either Connected or, if there is no connection
recognized to the rear panel J2 | Redundancy port, Not Connected.
•
Link – When a connection is recognized, the Link quality is also provided (e.g.,
Link=Good).
Ratio:<-11 dB
RemEsNo:+21.9 dB
LocEsNo:+21.9 dB
Freq-offset:+000.0kHz
Delay: 000000us
5–54
Revision 2
MN-CDM750
Advertisement
Table of Contents
