Table of Contents
Advertisement
CDM-750 Advanced High-Speed Trunking Modem
Ethernet-based Remote Product Management
6.5.4.5
Interfaces pages
Be sure to read Sect. 5.2.2.1.1 Single Stream Mode vs. MultiStream Mode
Operation in Chapter 5. FRONT PANEL OPERATION before you attempt to use
either of the Interfaces pages.
Take care to refer back to the Chapter 5. FRONT PANEL OPERATION content
sections additionally specified in the subsections that follow.
The Interfaces pages provide you with the means to configure and monitor the available
standard and optional Ethernet and traffic data interfaces. These pages refer to the connectors
and optional data interface modules that are available at the CDM‐750 rear panel:
•
The GBEI 1 (J5 | DATA) port;
•
The GBEI 2 (J6 | DATA) port;
•
The J7 | OPTICAL port, used with the optional Optical Ethernet SFP (Small Form Factor
Pluggable) Module;
•
PIIC (Plug‐In Interface Card) Slot 1 (PIIC1) and Slot 2 (PIIC2), which accept the optional
G.703 E3/T3/STS‐1, OC‐3 Single / Multi Mode, and STM‐1 Copper PIIC modules.
Click the Interfaces navigation tab, and then select the Ethernet or PIIC page tab to continue.
6–26
Revision 2
MN-CDM750
Advertisement
Table of Contents
