Suzuki WagonR+ RB310 Service Manual page 535

4A3-10 FRONT DRIVE SHAFT (Z13DT ENGINE MODEL)
10) Install damper (1) on right side drive shaft according to
dimension specified below.
Length "a": 337 – 343 mm (13.28 – 13.50 in.)
11) Set new differential side boot small band and differential side
boot (1) on shaft temporarily.
12) Install tripod joint (2) on shaft by using special tool with ham-
mer, facing its chamfered spline inward (wheel side), then
fasten it with snap ring (3).
Special tool
(A): 09900-06107
(B): 09925-98221
13) Apply grease to tripod joint and inside of housing then install
housing. Use grease supplied with spare parts.
Grease color: Black
Amount: Approximately 160 g (5.6 oz)
14) Fit boot to grooves of shaft and housing and adjust boot
length to specification below. Insert screwdriver into boot and
allow air to enter boot so that air pressure in boot becomes
the same as atmospheric pressure.
Length "a": Approximately 85.5 mm (3.37 in.)
CAUTION:
• To prevent any problem caused by washing solution,
do not wash boot and tripod joint except its housing.
Degreasing of those parts with cloth is allowed.
• Do not squeeze or distort boot when fastening it with
bands. Distorted boot caused by squeezing air may
reduce its durability.
[A]: Differential side
15) Install and fasten new boot big and small bands at that posi-
tion of step 14) in the same procedure as previous steps 6)
to 9).