Suzuki WagonR+ RB310 Service Manual page 446

6 2
1 5 6 4 6
6) Disconnect magnet clutch lead wire and disengage lead wire
clamp.
7) Remove compressor drive belt by loosening tension pulley
bolt (1) and adjust bolt (2).
8) Disconnect suction and discharge hoses from compressor.
NOTE:
Cap open fittings immediately to keep moisture out of
system.
9) Remove compressor with magnet clutch assembly (1) from
its mount by loosening mounting bolts (2).
10) Drain oil from compressor, and measure its amount.
Z13DT Engine Model
1) Run engine at idle speed with air conditioning ON for 10 min-
utes. After that stop the engine.
2) Disconnect negative (–) cable at battery.
3) Remove front bumper by referring to "Front Bumper and
Rear Bumper" in Section 9.
4) Remove belt (1).
5) Disconnect magnet clutch lead wire coupler (2).
6) Disconnect suction pipe (3) and discharge hose (4) from
compressor (5).
NOTE:
Cap open fittings immediately to keep moisture out of
system.
7) Remove compressor mounting bolts (6), and then remove
compressor (5) from its bracket.
3
AIR CONDITIONING (OPTIONAL) 1B-23