Suzuki WagonR+ RB310 Service Manual page 532

1
1
FRONT DRIVE SHAFT (Z13DT ENGINE MODEL) 4A3-7
7) Remove wheel side boot big band (1) as follows.
For boot big band without joint
a) Cut boot big band using a iron saw or a nipper with care not
to damage wheel side joint housing.
For boot big band with joint
a) Remove boot big band by using flat end rod or the like.
8) Remove wheel side boot small band, then pull out wheel
side boot from shaft.
[A]: For boot big band without joint
[B]: For boot big band with joint
For Cross groove joint type (left side)
CAUTION:
Disassembly of wheel side joint is not allowed. If any
abnormality is found, replace it as assembly.
1) Remove differential side boot big band (1) by using flat end
rod or the like.
2) Remove cross groove joint with housing from shaft as fol-
lows.
a) Fold over boot and remove old grease so that circlip (1) is
accessible.