Suzuki WagonR+ RB310 Service Manual page 472

7) Remove bushing.
Place suspension control arm onto flat surface side of spe-
cial tool and push out bushing with special tool and oil
hydraulic press as shown.
Special tool
(A): 09943-77910
Installation
1) Place suspension control arm onto flat surface side of spe-
cial tool and install new bushing with special tool and oil
hydraulic press as shown.
Special tool
(A): 09943-77910
NOTE:
• Before installing bushing, apply soap water on its cir-
cumference to facilitate installation.
• When installed, bush should be equal on the right and
left of arm as shown.
2) Install suspension control arm to vehicle body and tighten
suspension Control arm mounting bolt (1) and washer tem-
porarily.
FRONT SUSPENSION 3D-13