Suzuki WagonR+ RB310 Service Manual page 551

5A-2 BRAKES PIPE/HOSE/MASTER CYLINDER
Rear Brake Hose/Pipe
CAUTION:
• Do not use lubricated shop air on brake parts as damage to rubber components may result.
• If any hydraulic component is removed or brake line disconnected, bleed the brake system.
• The torque values specified are for dry, unlubricated fasteners.
• Do not allow brake fluid to get on painted surfaces. Painted surfaces will be damaged by brake fluid.
Removal
1) Raise and suitably support vehicle. Remove tire and wheel.
2) Clean dirt and foreign material from both hose end or pipe end fittings. Remove brake hose or pipe.
Installation
1) Reverse removal procedure for brake hose or pipe installation procedure.
• Install clamps properly referring to figure below.
• When installing hose, make sure that it has no twist or kink.
2) Fill and maintain brake fluid level in reservoir. Bleed brake system.
3) Perform brake test and check each installed part for fluid leakage.
On-Vehicle Service