Suzuki WagonR+ RB310 Service Manual page 526

General Description..................................... 4A3-1
Diagnosis...................................................... 4A3-1
On-Vehicle Service....................................... 4A3-2
Front Drive Shaft Assembly Construction .. 4A3-2
Front Drive Shaft Assembly Removal and
Installation .................................................. 4A3-3
Front Drive Shaft Assembly Inspection ...... 4A3-4
A constant velocity cross groove joint is used on the differential side of the left side drive shaft assembly.
A constant velocity tripod joint is used on the differential side of the right side drive shaft assembly. A constant
velocity ball joint is used on the wheel side of both the right and left drive shaft assemblies. The drive shaft can
slide through the tripod joint or cross groove joint in the extension/contraction direction.
Condition
Abnormal noise
SECTION 4A3
FRONT DRIVE SHAFT
(Z13DT ENGINE MODEL)
CONTENTS
General Description
Diagnosis
Possible Cause
Wear or breakage of the drive shaft joint
FRONT DRIVE SHAFT (Z13DT ENGINE MODEL) 4A3-1
Front Drive Shaft Components .................. 4A3-5
Front Drive Shaft Disassembly and
Assembly ................................................... 4A3-6
Front Drive Shaft Inspection .................... 4A3-12
Tightening Torque Specification.............. 4A3-12
Special Tools.............................................. 4A3-12
Replace.
4A3
Correction