Suzuki WagonR+ RB310 Service Manual page 458

"EPS" Warning Lamp Circuit Check Flow Table for M13 Engine Model
CAUTION:
Be sure to perform "System Check Flow Table" before starting diagnosis according to flow table.
Step
1 1) Make sure that battery voltage is about 11 V
or higher.
2) Note "EPS" warning lamp as ignition switch
is turned to ON position.
Does "EPS" warning lamp come ON when igni-
tion switch is turned to ON position?
2 Check that "EPS" warning lamp lights for 2 sec.
and then goes OFF.
Diagnosis
Action
ELECTRICAL POWER STEERING (EPS) SYSTEM (IF EQUIPPED) 3B1-3
Yes
Go to Step 2.
"EPS" warning lamp is in
good condition.
No
Proceed to "Table-A
"EPS" Warning Lamp
Does Not Light".
Check for any DTC refer-
ring to "Diagnostic Trouble
Code (DTC) Check" in
Section 6-1 for G10
engine model or in Sec-
tion 6-2 for M13 engine
model. If there is any,
troubleshoot the prob-
lem(s). If not, proceed to
"Table-B "EPS" Warning
Lamp Remains ON".