Front Drive Shaft Disassembly And Assembly - Suzuki WagonR+ RB310 Service Manual

FRONT DRIVE SHAFT (G10/M13 ENGINE MODELS) 4A-7

Front Drive Shaft Disassembly and Assembly

Disassembly
For DOJ type
CAUTION:
Disassembly of wheel side joint is not allowed. If any
abnormality is found, replace it as assembly.
1) Remove differential side boot big band (1) as follows.
• For boot big band without joint
Remove boot big band by tapping boot and band with plastic
hammer. If it is hard to remove boot big band, cut it using a
nipper or a iron saw with care not to damage DOJ housing.
• For boot big band with joint
Draw hooks of boot big band together and remove band.
[A]: For boot big band without joint
[B]: For boot big band with joint
2) Remove DOJ from shaft as follows.
a) Fold over boot and remove old grease so that retaining ring
(1) is accessible.
b) Clamp drive shaft in soft jawed vise, and then open retain-
ing ring using special tool and tap DOJ of drive shaft (1)
using plastic hammer until retaining ring no longer engages
in groove of shaft.
Special tool
(A): 09900-06107