Front Drive Shaft Disassembly And Assembly - Suzuki WagonR+ RB310 Service Manual

4A3-6 FRONT DRIVE SHAFT (Z13DT ENGINE MODEL)

Front Drive Shaft Disassembly and Assembly

Disassembly
For Tripod joint type (right side)
CAUTION:
• Disassembly of wheel side joint is not allowed. If any
abnormality is found, replace it as assembly.
• Do not disassemble tripod joint. If any malcondition is
found in it, replace it as differential side joint assembly.
1) Remove differential side boot big band (1) as follows.
For boot big band without joint
a) Remove boot big band by tapping boot and band with plas-
tic hammer. If it is hard to remove boot big band, cut it using
a nipper or a iron saw with care not to damage tripod joint
housing.
For boot big band with joint
a) Remove boot big band by using flat end rod or the like.
[A]: For boot big band without joint
[B]: For boot big band with joint
2) Take out tripod joint housing (2).
3) Remove grease from shaft, and then take off snap ring (1) by
using special tool.
Special tool
(A): 09900-06107
4) Remove tripod joint (1) by using 3 arms puller (2).
CAUTION:
To prevent needle bearing of joint from being degreased,
do not wash it if it is to be reused.
5) Remove differential side boot small band, and then pull out
differential side boot from shaft.
6) Pull out damper through shaft.