Suzuki WagonR+ RB310 Service Manual page 439

1B-16 AIR CONDITIONING (OPTIONAL)
Installation
Z13DT Engine Model
Reverse removal sequence to install condenser, noting the follow-
ing point.
• If replace condenser, pour 15 cc of refrigerating oil to com-
pressor suction-side.
• Evacuate and charge system according to previously
described procedure.
M13 and G10 Engine Models
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Inspection
Z13DT Engine Model
Check the following.
• Condenser fins for leakage, blockage and damage
• Condenser fittings for leakage
Clogged condenser fins should be washed with water, and should
be dried with compressed air.
NOTE:
Be careful not to damage condenser fins. If condenser fin
is bent, straighten it by using a screwdriver or pair of pli-
ers. If any leakage is found from fitting or tube, repair or
replace condenser.
M13 and G10 Engine Models
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.